please dont rip this site

SX Microcontroller port pins

"When I set a port pin as an input, then ground & unground it with a switch, it sometimes works & other times doesn't work."
You have a floating input; You want to use a pull-up or a pull-down resistor, if you are driving this pin with an open drain or a switch to Vcc or Ground, directly. 10k is a good value here. See Extra, unused pins

SX Microcontroler Port Setup

SX Microcontroller Input / Output Port Expansion

file: /Techref/scenix/lib/io/osi2/portpins_sx.htm, 0KB, , updated: 2005/11/30 16:32, local time: 2024/12/26 23:15,
TOP NEW HELP FIND: 
13.58.84.207:LOG IN
 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://linistepper.com/techref/scenix/lib/io/osi2/portpins_sx.htm"> PIC Microcontroller port pins</A>
After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?