please dont rip this site

Language Pcl LJ2079.ASC

USING  THE RELATIVE CHARACTER SIZE ( SR ) COMMAND

     
     The Relative Character Size ( SR ) command, specifies
     the size of labeling characters as a percentage of the
     distance between P1 and P2.  For more information see
     the PCL 5 Printer Language Technical Reference Manual.
     The syntax for this command is as follows:
     
     SR width, height; or SI;
     
     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT.
     
     
     EcE                           Resets the printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes HP-GL/2 mode.
     
     SP1;                          Selects pen number 1,
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     IP-6956,-4388,6956,4388;      Moves P1 to (-6956,-
                                   4388), and P2 to
                                   (6956,4388).
     
     DT@;                          Defines the label
                                   terminator as the "@"
                                   character.
     
     SR;PA0,2700;LBRELATIVE LABEL SIZE@;     Defaults the
                                   character size as a
                                   percentage of the P1/P2
                                   rectangle, and moves the
                                   pen to (0,2700); prints
                                   "RELATIVE LABEL SIZE".
     
     IP0,0,5500,5500;PA0,2000;     Moves P1 to (0,0) and P2
                                   to (5500,5500); moves the
                                   pen to (0,2000).
     
     LBNEW P1 AND P2 CHANGE LABEL SIZE@;     Prints "NEW P1
                                   AND P2 CHANGE LABEL
                                   SIZE".
     
     PA0,1000;SR2.5,2.5;           Moves to (0,1000) and
                                   sets the character size
                                   to 2.5% by 2.5% of the
                                   P1/P2 rectangle.
     
     LBNEW SR INSTRUCTION@;CP;     Prints "NEW SR
                                   INSTRUCTION" and sends a
                                   CP for Carriage
                                   Return/Line Feed.
     
     LBCHANGES LABEL SIZE@;        Prints "CHANGES LABEL
                                   SIZE."
     
     Ec%0A                         Enters PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.
     


            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.




file: /Techref/language/pcl/lj2079.asc, 2KB, , updated: 1993/11/15 16:26, local time: 2024/12/25 10:07,
TOP NEW HELP FIND: 
3.144.224.105:LOG IN

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://linistepper.com/techref/language/pcl/lj2079.asc"> language pcl lj2079</A>

Did you find what you needed?