Language Pcl LJ2015.ASC

USING  THE ABSOLUTE DIRECTION ( DI ) COMMAND

     
     The Absolute Direction ( DI ) command specifies the
     slope or direction at which characters are drawn,
     independent of P1 and P2 settings. For more information
     see the PCL 5 Printer Language Technical Reference
     Manual.  The syntax for this command is as follows:
     
     DI run,rise; or DI;

PARAMETERS:
     
     Run                           Specifies the X-component
                                   of the label direction.
     
     Rise                          Specifies the Y-component
                                   of the label direction.
     

PROGRAM:
     
     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT.
     
     
     EcE                           Resets the printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes HP-GL/2 mode.
     
     SP1;                          Selects pen number 1,
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     PA3500,2500;                  Specifies absolute
                                   plotting and moves to
                                   (3500,2500).
     
     DT*;                          Defines the asterisk (*)
                                   as the label terminator.
     
     DI1,1;LBDIRECTION CR*;        Prints the word
                                   "DIRECTION" at a 45
                                   degree angle up to the
                                   right; Carriage Return
                                   "CR" returns the pen to
                                   the Origin (3500,2500).
     
     DI1,-1;LBDIRECTION CR*;       Prints the same word, at
                                   a 45 degree angle up and
                                   to the left, followed by
                                   a "CR" to return the pen
                                   to the origin.
     
     DI-1,-1;LBDIRECTION CR*;      Prints the same word, at
                                   a 45 degree angle down
                                   and to the left, followed
                                   by a "CR" to return the
                                   pen to the origin.
     
     DI-1,1;LBDIRECTION CR*;       Prints the same word, at
                                   a 45 degree angle down
                                   and to the right,
                                   followed by a "CR" to
                                   return the pen to the
                                   origin.
     
     Ec%0A                         Enters the PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.


            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.