Language Pcl LJ1882.ASC

USING  THE AT COMMAND

     
     The AT command is Absolute Arc Three Point, and draws
     an arc segment, using absolute coordinates, from a
     starting point, through an intermediate point, to an
     end point.  For more information see the PCL 5 Printer
     Language Technical Reference Manual.
     
     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT
     
     EcE                           Resets the printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes HP-GL/2 mode.
     
     SP1;                          Selects pen number 1
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     PA1000,100;PD2500,100;        Specifies (1000,100) as
                                   the starting location,
                                   places the pen down, and
                                   draws a line to
                                   (2500,100).
     
     PU650,1150;PD1000,1150;       Lifts the pen up and
                                   moves to (650,1150), then
                                   places the pen down and
                                   draws a line to
                                   (1000,1150).
     
     PU650,450;PD1000,450;         Lifts the pen up and
                                   moves to (650,450) then
                                   places the pen down, and
                                   draws a line to
                                   (1000,450).
     
     PU1000,100;PD1000,1500,2500,1500;  Lifts the pen up and
                                   moves to (1000,100), then
                                   places the pen down and
                                   draws a line to
                                   (1000,1500), then draws a
                                   line to (2500,1500).
     
     AT3200,800,2500,100;          Prints an arc, starting
                                   at the current pen
                                   position (25,1500),
                                   passing through
                                   (3200,800) and ending at
                                   (2500,100).
     PU3200,900;PD;                Lifts the pen and moves
                                   it to (3200,900), and
                                   sets the pen down.
     
     AT3300,800,3200,700;          Prints an arc, starting
                                   at the current pen
                                   position, passing through
                                   (3300,800) and ending at
                                   (3200,700).
     
     PU3300,800;PD3500,800;        Lifts the pen to
                                   (3300,800) and then puts
                                   the pen down and draws a
                                   line to (3500,800).
     
     Ec%0A;                        Enters PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.
     
     
     
     
            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.