Note, remote connect to the Chilipeppr ws: address, not wss:. E.g. ws:192.168.1.17:8989/ws. Be sure to select grbl FIRST before connecting to the port.
Todo:
grbl 1.1f Settings:
$0=10 (step pulse length, microseconds) $1=25 (idle timeout, milliseconds) $2=0 (step pulse invert mask, ....xyz) $3=6 (direction invert mask, ....XYz) $4=1 (enable invert mask, ....xyZ) $5=0 (limit switch invert mask ) $6=0 (probe pin invert mask ) $10=1 (status report mask, position, no buffer) $11=0.010 (junction deviation, mm) $12=0.002 (arc tolerance, mm) $13=1 (report in inchse, not mm) $20=0 (soft limits disabled) $21=1 (hard limits enabled) $22=0 (homing disabled) $23=0 (homing direction invert map, ...+++) $24=25.000 (homing set speed, mm/minute) $25=500.000 (home seek speed, mm/minute) $26=250 (home switch debounce, milliseconds) $27=1.000 (after home pull off, mm) $30=1000 (max spindle speed, rpm) $31=0 (min spindle speed, rpm) $32=0 (laser mode, disabled) $100=1259.843 (X steps/mm) $101=1259.843 (Y steps/mm) $102=1259.843 (Z steps/mm) $110=500.000 (X max speed mm/minute) $111=500.000 (Y max speed mm/minute) $112=500.000 (Z max speed mm/minute) $120=10.000 (X Acceleration, mm/sec^2) $121=10.000 (Y Acceleration, mm/sec^2) $122=10.000 (Z Acceleration, mm/sec^2) $130=200.000 (X Max travel, mm) $131=200.000 (Y Max travel, mm) $132=200.000 (Z Max travel, mm)+
file: /Techref/member/JMN-EFP-786/sherline-cnc-mill.htm, 1KB, , updated: 2022/2/21 16:51, local time: 2024/12/25 08:28,
owner: JMN-EFP-786,
3.147.27.154:LOG IN
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://linistepper.com/Techref/member/JMN-EFP-786/sherline-cnc-mill.htm"> Sherline CNC Mill</A> |
Did you find what you needed? |