Language Pcl LJ1903.ASC

DRAWING RECTANGLES USING EA

    
     The commands to draw rectangles in HP-GL/2 are EA ,
     Edge Rectangle Absolute , and ER , Edge Rectangle
     Relative. To use these commands, the printer uses the
     current pen location for one corner and you give the
     coordinates for the diagonally opposite corner. This
     example uses EA to draw the rectangle.  For more
     information see the PCL 5 Printer Language Technical
     Reference Manual.
     
     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT.
     
     
     EcE                           Resets the printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes HP-GL/2 mode.
     
     SP1;                          Selects pen number 1,
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     PA10,10;                      Specifies absolute
                                   plotting, then moves to
                                   (10,10).
     
     EA2500,1500;                  Draws the outline of a
                                   rectangle with the lower
                                   left corner being the
                                   current pen location,
                                   (10,10), and the upper
                                   right corner being
                                   (2500,1500).
     
     Ec%0A                         Enters PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.
     
     
     
            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.